Led Lenser®
*
EN Operating instructions P6X_V.01 | 7/31/2014
14
is activated. Use this method to select from the following
programs
:
Program A
Press the push button
Light function
1 x
High Power
2 x
Power (normal)
3 x
Low Power (dimmed)
Program B
Press the push button
Light function
1 x
Low Power (dimmed)
2 x
Power (normal)
3 x
High Power
1. Switch flashlight off.
2. To change the lighting program, press the On/Off push
button 8 times (or more) and then engage.
→
The flashlight switches the lighting program and
indicates this by briefly flashing twice.
→
After the flash, the first lighting function for the
relevant program will be selected, thus, either High
Power or dimmed light will be used.
→
Repeating the process switches back into the other
lighting program.
5.6 Replacing the Batteries/Battery Pack
1. To remove the battery pack② unscrew the end cap ③.
2. Remove the batteries/battery pack ②, dispose of the
batteries appropriately and replace, recharge battery
packs.
CAUTION
RISK OF eXPLOSION
Always insert batteries/battery packs
according to the (+/-) markings as there
is otherwise a risk of damaged or even
exploding batteries.
3. New batteries/battery packs ② must be inserted with the
plus pole (+) first into the battery compartment ①.
4. Screw the end cap ③ back into place.
ATTeNTION
USING BATTeRIeS/BATTeRY PACKS
The flashlight may only use 2 x AA batteries (LR6)
or 2 x AA NiMH battery packs with 1.5 V.
5. Operation
+
-
AA Alkaline
+
-
AA Alkaline
+
-
AA Ni-MH
+
-
AA Ni-MH
LED LENSER®* P6X
3
2
1
