Lectrotab MLC-1 Installation & Operation Manual Download Page 8

Page: 8 / 11

Programming MLC-1

(Single actuator, Single station)

Automatic Tab Adjustment to Last Setting:

When the accessory switch or ignition key switch (connected to keypad terminal #7) is
turned off, the tabs will automatically retract. When the accessory switch or ignition key
switch is turned back on, the tabs will adjust to the last know position before key switch
was turned off. You may enable this feature by adjusting program setting #1 to a value
showing LED R2 from the programming chart (see programming chart). Turning the main
power supply or battery selector switch to the off position will erase or reset the last tab
setting, so a new setting will be saved for the next trip.

Set Actuator Deployment Time:

Follow the programming chart below to program the MLC keypad to match the actuator

deployment time. Actuators that begin with part number or serial number “A or B” have

an 8 second deployment time. This is the default time and no programming is necessary.

Actuators that begin with “C or D” have a 4 second deployment time and must be
programmed to 4 seconds. Actuators that begin with “S” have a 6 second deployment

time and must be programmed to this.

Change LED Indicator Tracking:

The LED indicators are set to show the approximate tab angle and movement which is the
default  setting.  This  setting  may  be  changed  to  show  what  direction  the  port  and
starboard  side  is  moving.  This  setting  can  be  changed  by  following  the  program  chart
below and changing setting  L3 to R2.

Flashing Led indicates
Setting:
L1=top left LED
L2=second left LED
L3=third left LED

Press and release left button
to adjust betwee

n “Settings”

L1=top left LED, L2=second
left LED down, L3=third left
LED

Press top and bottom buttons

simultaneously for 4 seconds to

enter program mode and again

to exit and save.

Press and release right button to

change Setting Value.

LED indicates Setting Value:

R1=top right LED