6
4.
Terminal 7 must be connected to ignition key run position or accessory switch
to automatically retract the tabs when key is switched to OFF.
Verify Display Settings and Operation MLC-1
(Single actuator, Single station)
Set Actuator Deployment Time:
Follow the programming chart and instructions on page 7 to program keypad to match
the actuator deployment time.
Verify Connection and Operation:
1.
Press the “Bow Down” button (top button), and both actuators/tabs deploy
simultaneously.
2.
Press the “Bow Up” button (bottom button), and both actuators/tabs will re
tract
simultaneously.
3.
If the tab or tabs are moving in the opposite direction as described, switch the two
actuator wires from the actuator that moves in the wrong direction ((move 3 to
position 4 and 4 to position 3 for port actuator) at the 7 pin plug, and switch 5 and 6 in
the same manner for the starboard actuator and repeat the testing process).
4.
Press the “Starboard Side Down” button (right button), and the starboard actuator will
retract until fully retracted at which point the port actuator will deploy.
5.
Press the “Port Side Down” button (left button), and the port actuator will retract until
fully retracted at which point the starboard actuator will deploy.
6.
If the wrong tab is moving as described in step 4 and 5, exchange wires 3 and 4 with 5
and 6 at the green 7 pin plug and repeat the testing process.
Photo sensor to
automatically brighten
and dim LEDs
LEDs indicate tab
position
Adjust Bow Down or Bow
Up Buttons. Adjusts both
tabs simultaneously
Adjust Port or Starboard
sides up or down
MLC-1 Display
Summary of Contents for MLC-1
Page 11: ...11...
