Wideband Hand Held Transmitter
Rio Rancho, NM
7
Battery Installation
To insert batteries, close the eject lever and insert the
upper contacts first (closest to the mic capsule). Polar-
ity is marked on the label in the bottom of the battery
compartment.
Close
eject lever
to install
batteries
To remove the batteries, pull the eject lever outward.
The battery tips will move outward, making them
easier to grasp.
Pull eject lever outward to release batteries from contacts
The contacts are very tight to prevent the batteries
from “rattling” as the transmitter is being handled.
IR Sync
The IR SYNC (infrared sync) port is used with receiv-
ers that offer this feature. Settings stored in the receiv-
er for frequency, step size and compatibility mode are
transferred to the transmitter via the infrared ports. To
use this feature, open the housing on the transmitter to
expose the control panel. Hold the transmitter near the
receiver (less than 3 feet away) so the IR ports face
each other. The transfer is triggered by a switch on the
receiver. The LCD on the transmitter will display a
message confirming that the settings were success-
fully transferred, or an error message that identifies the
problem that occurred.
IR Sync
COMPAT
Mismatch
IR Sync
OK
Control Panel
Six membrane switches on the control panel are used
to set up the transmitter by navigating the menus on
the LCD and selecting the desired values.
Power Button
Side Button
Setup Switch
Modulation
LEDs
Previous
Screen
UP/DOWN Buttons for
Menu Item Selection
Enter Menu and
Select Item
IR Sync Port
Setup and Adjustments
Powering On
Press and hold the
Power Button
for several seconds
until a countdown on the LCD is completed. The
countdown from 1 through 3 will appear on the LCD,
followed by a display of the model, firmware version,
frequency band and compatibility mode.
Hold
for
Rf On
...3
HHa
V1.01
Blk 24
Hybrid
When you release the button, the unit will be opera-
tional with the RF output turned on and the
Main
Window
displayed.
5
623.400
-40
-20
0
A
The Main Window
NOTE: If the
Power Button
is released before the
countdown is completed, the unit will boot up in
the “standby” mode with the RF output turned off.
