Wideband Hand Held Transmitter
Rio Rancho, NM
17
Specifications
Operating frequencies:
†
Band A1:
470.100 - 537.575
Band B1:
537.600 - 614.375
Band 606: 606.000 - 631.500
Band C1:
614.400 - 691.175
Channel Step Size:
Normal Tuning mode:
100 kHz
Fine Tuning mode:
25 kHz
RF Power output:
Selectable at 50 or 100 mW
Pilot tone:
25 to 32 kHz frequency; 5 kHz deviation
(Hybrid, IFB, 200 Series, Mode 6)
Frequency stability:
± 0.002%
Deviation:
± 75 kHz max. (Digital Hybrid mode)
Spurious radiation:
90 dB below carrier
Operating temperature range:
-20° C to +50° C
Input compressor:
Dual envelope compressor, >30 dB range
Audio Gain range:
0 to 45 dB; menu selectable
Modulation indicators:
Dual bicolor LEDs indicate modulation
of -20, -10, 0 and +10 dB referenced to full
modulation, LCD bar-graph indicator
Frequency response
40 Hz to 20 kHz (+/- 1dB)
Low frequency roll-off:
-3 dB selectable @35, 50, 70, 100, 125 Hz,
36 dB/octave (varies slightly w/ selection)
Controls:
External:
Programmable mute/talkback button
Internal control panel:
Power, Side Button Setup, MENU/SEL, BACK
and Up/Down arrow buttons for menu item
selection and settings.
Battery:
(2) AA with polarity protection and
battery ejection lever
Battery Life:
5.5 hours (Duracell Quantum alkaline)
Battery Status Indication:
Transmitted to Lectrosonics Digital Hybrid and
200 Series receivers
Capsule Interface:
1.25 in. diameter x 28 thread pitch
Capsule Power available:
5V, 25 mA max
Input impedance:
1000 Ohms
Weight:
12.1 oz. with batteries and HHC capsule
Dimensions:
9.5” long x 1.97” diameter at largest point with
HHC capsule attached
Emission Designator:
180KF3E
Specifications subject to change without notice.
FCC Compliance:
This device complies with FCC radiation exposure
limits as set forth for an uncontrolled environment.
This device should be installed and operated so
that its antenna(s) are not co-located or operating
in conjunction with any other antenna or transmit-
ter.
Notice to the End User:
The normal condition of using this device is to
keep the hand at least 20mm away from the base
of the microphone.
Industry Canada Compliance:
This device operates on a no-protection no-
interference basis. Should the user seek to obtain
protection from other radio services operating in
the same TV bands, a radio license is required.
Please consult Industry Canada’s document CPC-
2-1-28, Optional Licensing for Low-Power Radio
Apparatus in the TV Bands, for details.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference
received, including interference that may cause
undesired operation of the device.
Cet appareil est conforme à Industrie Canada
une licence standard RSS exonérés (s). Son
fonctionnement est soumis aux deux conditions
suivantes:
1. Cet appareil ne doit pas provoquer
d’interférences
2. Cet appareil doit accepter toute interférence
reçue, y compris les interférences pouvant provo-
quer un fonctionnement indésirable de l’appareil
† Not all frequency bands are available in all countries. Consult your local
representative or contact Lectrosonics for more information.
