3. IDENTIFICATION OF THE UNIT
The unit, model and serial number are identified by means of the information displayed on the
registration or on the data sheet that appears on all the products.
4. START-UP
The unit, model and serial number are identified
by means of the information displayed on the
registration or on the data sheet that appears
on all the products.
Once the inside of the unit is clean, connect
•
the power supply and place the switch in
the On or I position. The switch should be lit up.
The thermostat display shows the air temperature inside the unit.
•
Three minutes after turning on the switch, the LED showing the compressor is working will light
•
up permanently.
The initial temperature that is shown on the thermostat display will be the ambient temperatu-
•
re. As the machine works, the temperature will reduce until it reaches its operating temperatu-
re.
The units for storage of frozen foods are programmed to defrost two hours after starting opera-
•
tion.
It is important that the unit runs until it reaches its operating temperature before proceeding to
•
load the unit with products.
www.lec-commercial.co.uk
7
Apart from the identifying data of the unit, information relating to the electrical voltage to which
the unit must be connected is also displayed.
Apart from the identifying data of the unit,
information relating to the electrical voltage to
which the unit must be connected is also
displayed.
