Mode 3: Count-Up
COUNT-UP
mode tracks how long the Tag is away from the Base Unit. This mode
can be used to track time for hall or visitor passes, or other activities requiring a
measure of elapsed time like a stopwatch.
UP
will flash indicating this mode is selected.
COUNT-UP
mode sets the Base Display time and associated Tag to 00:00:00
without flashing.
It is not possible to enter a target time in Count-Up mode using
the HR, MIN, and SEC buttons.
Remove the Tag from the Base Unit to begin counting upwards from 00:00:00.
Replace the Tag in its dock and press the STOP button to mark the amount of
time the Tag was away from the Base Unit.
If Stop is not pressed, a docked Tag in COUNT-UP mode will continue counting up
to 99:59:59 before returning to 00:00:00 and counting up again.
Press and hold the Stop button until the Base Display begins to flash. This will
clear the marked COUNT-UP time to 00:00:00.
After a COUNT-UP Tag has been stopped, the marked time will remain on the Tag
and Base Displays until the Tag is reprogrammed or removed from the base, or
until Stop is pressed and held to clear the marked time.
Removing the Tag from the Base Unit will always trigger the COUNT-UP Tag to
begin a fresh count from 00:00:00.
3. Understanding Alarm Notifications
Alarm notifications occur for Tags in COUNTDOWN Modes 1 and 2. Because the
COUNT-UP mode is open-ended, there are no alarm notifications for Tags in
Mode 3: COUNT-UP.
Light-alarm notifications
Light-alarm notifications are always enabled for both the Tags and Base Unit.
30 seconds remaining
The light on the programmed Tag and the corresponding status light on the Base
Display will flash beginning at 00:00:30 until the countdown timer expires at
00:00:00.
Time expiration 00:00:00
The light on the programmed Tag and the corresponding light on the Base Display
will remain lit until the Tag is returned to the appropriate dock in the Base Unit.
To conserve battery power, the light will shut off after 3 minutes if the expired Tag
has not been returned to the Base Unit.
Audio-alarm notifications
30 seconds remaining
If enabled, a tone on the Tag and Base Unit will quickly beep three times.
00
00 00
00
00
00
COUNT
COUNT
UP
UP
s
s
s
4
