WinFast
®
6000ABX User’s Manual
45
OFFENDING SEGMENT:
This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY
ERROR messages when the segment that has caused the problem has been isolated.
PRESS A KEY TO REBOOT
This will be displayed at the bottom screen when an error occurs that requires you to reboot.
Press any key and the system will reboot.
PRESS F1 TO DISABLE NMI, F2 TO REBOOT
When BIOS detects a Non-maskable Interrupt condition during boot, this will allow you to
disable the NMI and continue to boot, or you can reboot the system with the NMI enabled.
RAM PARITY ERROR - CHECKING FOR SEGMENT ...
Indicates a parity error in Random Access Memory.
SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT ...
Indicates the present boot attempt has been aborted and the system must be rebooted. Press and
hold down the CTRL and ALT keys and press DEL.
FLOPPY DISK(S) fail (80)
→
→
→
→
Unable to reset floppy subsystem.
FLOPPY DISK(S) fail (40)
→
→
→
→
Floppy Type dismatch.
Hard Disk(s) fail (80)
→
→
→
→
HDD reset failed
Hard Disk(s) fail (40)
→
→
→
→
HDD controller diagnostics failed.
Hard Disk(s) fail (20)
→
→
→
→
HDD initialization error.
Hard Disk(s) fail (10)
→
→
→
→
Unable to recalibrate fixed disk.
Hard Disk(s) fail (08)
→
→
→
→
Sector Verify failed.
Keyboard is locked out - Unlock the key.
BIOS detect the keyboard is locked. P17 of keyboard controller is pulled low.
Keyboard error or no keyboard present.
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are
being pressed during the boot.
Manufacturing POST loop.
System will repeat POST procedure infinitely while the P15 of keyboard controller is pull low.
This is also used for M/B burn in test.
BIOS ROM checksum error - System halted.
The checksum of ROM address F0000H-FFFFFH is bad.
