lemaitrefx.com
6
1. Remove the six screws from the case. Four are under the lip at mid level and two are
on top. Remove the bolt from the front of the fluid jug. Slide the upper cover forward
and remove it from the machine. Lift the jug up and out of the way.
2. Remove the two screws from the front edge of the
block cover. Slide the cover backward to release the
two back tangs from the lower cover and lift the
cover off.
3. Unfasten the tube by releasing the 7/16” brass nut
at the pump. This line may be under significant
pressure if the tube was plugged.
4. Be careful not to damage any exposed wiring. Re-
move the upper steel plate by loosening the five
nuts with a 1/2” socket. Gently lift the plate back
out of the way leaving the high temperature switch
undisturbed.
5. Lift the aluminum plate up cautiously to avoid damage to the Thermal sensor.
6. Remove the copper tube and two thin aluminum wear plates.
The block contains extremely hot surfaces and liquids. These
will cause severe burns on contact. Please unplug power to
eliminate electrocution hazard and allow the unit to cool
before attempting to service the block.
Show Fogger Tube Change Procedure
