lemaitrefx.com
1) The Show Fogger Pro must only be connected to a grounded mains supply capable
of sustaining at least 15 Amps. The supply should be ‘clean’ and free of interference.
2)
Open a container of Le Maitre fog fluid , remove cap and break foil seal (if provided).
Remove cap from Show Fogger Pro fluid resevoir. Fill with fluid, being careful not to overfill
resevoir. Replace both caps securely.
3) Connect the remote handset supplied with the machine, to the connector which is
located on the rear panel.
4)
Activate the
Mains On
switch located on the rear panel. The Mains On switch will
illuminate to indicate the presence of power, the
handset
indicator on the remote
handset will also illuminate (or slow flash on startup). If the handset indicator of the
remote handset does not illuminate, ensure the connector is properly inserted.
5) The
handset
indicator will flash slowly as the machine heats up.The indicator will
begin flashing quickly when the fog machine is ready to operate. Fog is available at this
point, but full fog output will not be available. After approximately 9 minutes the
indicator will be solid when the fog machine has fully heated and is ready for use at full
fog output if required.
6) It may now be necessary to
prime
fluid into the system to expel any air that might
be present. The
Variflow
control on the remote handset should be set to Full position. A
dry hose can take between45 - 60 seconds to prime. This is normal because of the inside
diameter of the hose. This only needs to be done if the unit was left to run dry.
7)
Activating the
Smoke
switch will effect a pulsing fluid flow which will prime the
machine correctly. Once primed (when there is no more sporadic output) the controls on
the remote handset can be set as desired.
Industrial Option Only!
To adjust the depth of the hose, simply loosen Nut ‘A’ and slide it up or down the hose
and retighten. Be careful not to pinch off the flow of fluid.
4
Operating Procedure
In order to prime the fog machine, the handset
indicator must be a solid red.
Note:
