Arpa F & PC 150 LED User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
3
1. BOX CONTENTS
Upon opening the packaging, please make sure it contains the following:
a.
lighting unit in the chosen model
b.
metal colour frame 150x150mm, fitted
c.
Neutrik PowerCon blue connector
d.
160cm mains power cable
Should one or more items miss, we kindly ask you to contact your dealer immediately.
2. WEIGHT AND DIMENSIONS
Arpa f150 LED
Arpa pc150 LED
net weight: 9,7 kg
net weight: 10,1 kg
gross weight: 11,9 kg
gross weight: 12,3 kg
packing dimensions: 56x40x45h cm
packing dimensions: 56x40x45h cm
3. MECHANICAL OPERATION
The mounting stirrup
is designed to allow the spotlight to be suspended from above using a C-clamp or similar, or
supported on a stand or bracket from below.
Note:
the spotlight’s location must provide suitable ventilation for the LED
module.
Focus control:
is located on the rear end of the product. Turn the knob clockwise to narrow the beam (SPOT). Turn the
knob anticlockwise to widen the beam (FLOOD) . The beam distribution (peak/flat) is fixed.
Beam-shaping:
a 4 leaf barndoor (A20100306) can be fitted on the front of the Arpa to control and shape the beam
4. WIRING
Before being connected to the mains power, this unit may need to be wired with a suitable plug if not already installed.
Make sure the plug you are using is rated for the proper power load and it conforms to the relevant EU/UL electrical
standards.
•
Make sure the plug you are fitting withstands the lamp power load.
•
This fixture must be grounded
•
To perform a correct wiring, please note that the cores in this mains lead are colour-coded as follows:
Ground: green+yellow – Neutral: blue - Phase: brown
In case the colours of the wires do not correspond to the colour of the connection points on your plug, please proceed as
follows:
•
The green or green and yellow wire must be connected to the connection point marked with the letter E or with the symbol
or coloured in green or in green-yellow
•
The blue wire must be connected to the connection point marked with the letter N or coloured in black
•
The brown wire must be connected to the connection point marked with the letter L or coloured in red
•
Before you finally position this product for use, temporarily connect it to a properly fused power supply to check the lamp
works correctly.
