25
Wiring and operating Uncoupling Tracks (ASC2 single-address mode)
Refer to the figure below to wire an Uncoupling Track section (available separately, part no.
6-65530). To avoid the possibility of damage to your uncoupling tracks, your ASC2 should be
set to Single ID addressing mode (see page 17).
Follow these steps to operate the Uncoupling Track section.
1. Press ACC on the CAB remote controller.
2. Using your CAB remote controller, Enter the ASC2's TMCC ID base address.
3. Press the numbered key matching the terminal connected to your track (2, in this
example). The magnetic uncoupling disk will be briefly activated, then automatically
turn off.
LCS PDI CABLES
use either connector
AC Power
PROGRAM
A U A
U
SWITCH
ACCESSORY
SWITCH
ACCESSORY
COMM
COMM
4 O
8
4 T
7
3 O
6
3 T
5
2 O
4
2 T
3
1 O
2
1 T
1
ASC2
6-81327
Uncoupling Track
Figure 15. Uncoupling track wiring diagram.
Accessory examples
