22
For HELP, call La-Z-Boy
®
Spas at 1.800.465.2933.
Before Adding Water
Before adding water, go through these simple steps now to prevent common issues
when setting up your
spa
/ hot tub for the first time. Verify that the following have all
been rechecked.
1. Turn off all power at the main breaker panel or unplug.
2. Open the front panel to access the internal components.
3. Check that all gate valves are opened (service handles
in the up position).
4. Check that there are no obvious signs of loose wires or
broken pipes.
5. Check that the two heater unions are tight.
Figure 6 - Valve Open
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or inside of the
spa / hot tub
itself.
8. With the drain open and filters removed, thoroughly rinse out the
spa / hot tub
with
warm water until the drained water runs clear. Run water through the filtration
canister and jet lines to remove any incidental dust, dirt, and debris that may have
accumulated during shipment or installation. Drain all water completely.
9. Make sure that the
spa / hot tub
drain valve is closed and the cap is on tight (see
page
42
).
10. Install the filter in the filtration canister.
11. Now is the best time to clean and polish the surface of your
spa
(see page
43
).
CAUTION:
Do not use a wrench. Over
-tightening may cause damage
to unions and gaskets, which will
not be covered the Guarantee.
Figure 7 - Tighten Directions