Power Storage Console
Assembly Instructions
7
6
NOTICE:
Do not plug in until instructed.
The power console has one side mount locking latch bracket and one side mount latch bracket
on the right side (sitting), and two threaded studs on the left side (sitting), (F
IGURE
1).
1. Use a T-30 torx driver to loosen the threaded studs to approximately 1", this measurement
may vary depending on the fabric and style (F
IGURE
2).
2. Align the units to be joined next to each other. Move the unit with the latch brackets
approximately 4" forward of the unit with the threaded studs.
3. Slide the unit with the latch brackets back until the threaded studs are securely engaged in
both the front and rear latch brackets. The rear bracket is not a locking bracket.
4. Continue connecting the modular units until all have been securely joined. Refer to the Reclining
Sofa Operating Instruction manual or the Power Recline Operating Instructions manual for assembly
instructions for all motion-modular units.
NOTICE:
To reduce the risk of product damage:
•
Do not move the units while latched together. The purpose of the latch bracket system
is to connect the units and prevent them from being separated. The latch bracket system
does not provide adequate structural support for the movement of connected units.
5. All modular units must be disconnected to safely move the modular group. To disconnect the units,
apply pressure to the swing arm of the locking latch bracket (F
IGURE
3) and slide the unit forward.
Repeat this step to disconnect the remaining units.
Power Storage Console
Assembly Instructions
Side Mount
Latch Bracket
F
IGURE
1
F
IGURE
2
F
IGURE
3
Side Mount
Locking Latch
Bracket
Threaded
Stud
Threaded
Stud
Side Mount
Locking Latch
Bracket
