LAWO mc256 MKII, Technical Manual

Page: 358 / 372

mc²56 MKII Technical Manual V5.10.2/1 358
Chapter 7: Appendices
SDI Parameters
Embedder
·
Clean – check this option to set the embedder mode to “Clean”. In this mode the incoming audio stream
is deleted and a new data structure generated according to your embedder settings. Note that if you
select this mode any existing audio data will be lost.
·
Embedder Group Enable – audio is embedded in groups of four channels into SDI. There is a total of
four groups per SDI, resulting in 16 audio channels. For each group, this checkbox determines whether
the incoming SDI stream is replaced:
o
Enable the checkbox to replace the audio group content.
o
Disable the checkbox to leave the audio group untouched.
If there is no audio at the SDI input, then a new audio group will be generated.
Note that in AdminHD modes 16/0 and 8/0, all embedder group enables are turned off as the whole embedder
section is bypassed.
·
Embedder source 1 to 16 – use these options to define the source for each embedder.