edge - User Manual
Version: 1.0.13/1
Exported on: 22 February, 2024
47
/
154
•
•
To achieve redundant control, you must use both interfaces.
If you are using in-band control, then the management ports are addressed via the media ports/network (and the physical
MGMT ports can be left unconnected).
To use the network ports, you must fit the correct optical transceivers. These must be Lawo-certified (as described earlier).
The optical transceiver determines the cable type, maximum distance and connector.
4. SDI Interfaces (48 x HD-BNC)
5. Reference Interfaces (5 x HD-BNC)
For external synchronization, there are 5 x HD-BNC connectors: 2 x REF IN, 2 x REF THRU and 1 x REF OUT.
The two reference inputs can be used to connect up to two external sync reference signals. In each case, the THRU
connector provides a "looped-through" output of the corresponding IN.
The REF OUT is always active and provides an output of the current reference: External IN 1, External IN 2, PTP or
Internal (free-run).
The current reference can be changed using the HOME Web UI. For more information, see .edge - Synchronization.
6. Grounding Screw (M5x12)
A grounding screw is provided on the right side of the frame (when viewed from the rear). See
for more
information about the safety requirements.
Summary of Contents for edge
