12
CLEANING
1. Keep your machine clean, the outside of the machine can be cleaned using a damp
soft cloth, never use water to clean the machine as it may cause damage to internal
parts.
2. Some maintenance products and solvents may damage the plastic parts, these
include products containing benzene. Trichloroethylene, chloride and ammonia.
3. Take special care to keep the ventilation inlets /outlets free from obstruction. Cleaning
with a soft brush followed by a compressed air jet will usually be sufficient to ensure
acceptable internal cleanliness.
4. Wear eye protection when carrying out cleaning.
IDLE SPEED SETTING
The screw just behind air filter cover regulates the throttle setting at idle speed. The user
can adjust the idle speed
, if it’s necessary.
Before any adjustment, make sure that the air filter is clean and the air filter cover is fitted.
Turn the screw clockwise can give a higher idle speed; turning it anti-clockwise gives a
lower idle speed.
The idle speed is correctly adjusted when the engine runs smoothly in every position.
There should also be a clear margin to the speed at which the blades start to move. The
blades must also remain stationary when the choke control is in the start throttle position.
(1) Idle adjusting screw (2) Higher speed (3) Lower speed
CUTTING BLADE CARE
Clean any resin and plant residue from the blades using cleaning agent before and after
using the machine. Lubricate the blades with a light anti-corrosion oil after cleaning.
Failure to do this can damage the gearbox and clutch mechanism.
