background image

 

2005—Lawn-Boy, Inc.

8111 Lyndale Ave., Bloomington, MN 55420, USA

Printed in the USA

All Rights Reserved

Original Instructions (EN)

Register your product at www.lawn-boy.com

Insight

t

Lawn Mower

Model No. 10695—Serial No. 250000001 and Up

Form No. 3352-951 Rev B

Operator’s Manual

If you have questions or problems, contact us at www.lawn-boy.com

or call toll free 1-866-216-6032 (US) or 1-866-216-6031 (Canada) 

before returning this product.

Introduction

Read this manual carefully to learn how to operate

and maintain your product properly and to avoid injury

and product damage. You are responsible for

operating the product properly and safely.
You may contact Lawn-Boy directly at

www.lawn-boy.com for product and accessory

information, help finding a dealer, or to register your

product.
Whenever you need service, genuine Lawn-Boy

parts, or additional information, contact an Authorized

Service Dealer or Lawn-Boy Customer Service and

have the model and serial numbers of your product

ready. The illustration below identifies the location of

the model and serial numbers on the product. Write

the numbers in the space provided below:

Model #:

Serial #:

m-7915

This manual identifies potential hazards and has

safety messages identified by the following words:

Danger

 signals an extreme hazard that 

will

cause serious injury or death if you do not follow

the recommended precautions.

Warning

 signals a hazard that 

may 

cause

serious injury or death if you do not follow the

recommended precautions.

Caution

 signals a hazard that may cause minor

or moderate injury if you do not follow the

recommended precautions.

This manual uses two other words to highlight

information. 

Important:

 calls attention to special

mechanical information and 

Note:

 emphasizes

general information worthy of special attention.

Warning

The engine exhaust from this product contains

chemicals known to the State of California to

cause cancer, birth defects, or other reproductive

harm.
Important

: This engine is not equipped with a spark

arrester muffler. It is a violation of California Public

Resource Code Section 4442 to use or operate this

engine on any forest-covered, brush-covered or

grass-covered land. Other states or federal areas

may have similar laws.
This spark ignition system complies with Canadian

ICES-002.
The enclosed Engine Owner’s Manual is supplied for

information regarding The U.S. Environmental

Protection Agency (EPA) and the California Emission

Control Regulation of emission systems, maintenance

and warranty. Replacements may be ordered through

the engine manufacturer.

Safety

This lawn mower meets or exceeds the CPSC blade

safety requirements for walk-behind rotary lawn

mowers and the B71.1 specifications of the American

National Standards Institute in effect at the time of

production.

Read and understand the contents of this manual

before the engine is ever started.

 This is the safety alert symbol. It is used to

alert you to potential personal injury hazards.

Obey all safety messages that follow this symbol

to avoid possible injury or death.
Improperly using or maintaining this mower

could result in injury or death. To reduce this

potential, comply with the following safety

instructions.

The following instructions have been adapted from

the ANSI/OPEI standard B71.1—2003.

Summary of Contents for Insight 10695

















Reviews: