13
3352-951 Rev B
Lubricating the Wheel
Gears
1.
Remove the wheel bolt in the center of each
rear
wheel and remove the rear wheels.
2.
Apply a lubricating
oil to the inner and outer
sides of the gear as
shown.
m-5646a
3.
Install the rear wheels.
Lubricating the Upper
Handle
Lubricate the left and right sides of the upper handle
with a low-viscosity silicone spray lubricant yearly or
as needed.
1.
Spray the outer plastic end of the inner handle.
m-8015
m-8014
Note:
Use the straw that comes with the spray
can to direct the spray.
2.
Push the upper handle fully down and spray the
inner plastic surface of the outer handle.
m-8014
m-8016
Adjusting the Self-propel
Drive
If your mower does not self-propel properly, adjust the
self-propel drive cable.
1.
Loosen the nut on the cable mount (A).
A
2.
Pull the upper handle back fully rearward.
Note:
If the handle does not move smoothly, refer
to Lubricating the Upper Handle section.
3.
Pull the cable jacket downward until you remove
the slack in the exposed cable (B).
B
