Setup and Use
11
1.
First, complete all steps listed in the section titled
Setup for Playback Listening
included
previously in this chapter of the manual.
2.
Select
CH1
and lower the Volume to zero.
3.
Select
CH2
and lower the Volume to zero.
4.
Connect one live signal source to
CH1/Mono Input
.
5.
Connect the 2nd live signal source to
CH2 Input
.
6.
Select
CH1
and raise the Volume to the optimal level.
7.
Select
CH2
and raise the Volume to the optimal level.
1.
First, complete all steps listed in the section titled
Setup for Playback Listening
included
previously in this chapter of the manual.
2.
Select
CH1+2
and lower the Volume to zero.
3.
Connect a live stereo signal source to the
CH1/Mono Input
and to the
CH2 Input
. Use balanced
cables
for balanced signals or unbalanced cables for unbalanced signals.
4.
Connect
CH1 Output
and
CH2 Output
to the analog record inputs of your DAW. Use balanced
cables
for balanced signals or unbalanced cables for unbalanced signals.
5.
Select
CH1+2
and raise the Volume to the optimal level.
CH1+2, CH1
, and
CH2
are three completely independent Volume settings. Changing the Volume of
CH1
or
CH2
does not affect the Volume of
CH1+2
, or vice versa. By selecting either
CH1
or
CH2
and rotating
the knob, the unit will suddenly switch to stereo mode Volume settings. If
CH1
or
CH2
are set to a much
higher Volume setting than
CH1+2
, a sudden increase in loudness will be heard, and damage to
hearing/headphones may result. To prevent damage in case of accidentally switching to stereo mode, it
is highly recommended to make sure that
CH1
and
CH2
are both muted during setup.
CH1+2, CH1
, and
CH2
are three completely independent Volume settings. Changing the Volume of
CH1
or
CH2
does not affect the Volume of
CH1+2
, or vice versa. By selecting
CH1
+
CH2
and rotating the knob,
the unit will suddenly switch to mono mode Volume settings. If
CH1+2
is set to a Volume much higher
than
CH1
or
CH2
, a sudden increase in loudness will be heard, and damage to hearing/headphones may
result. To prevent damage to in case of accidentally switching to mono mode, it is highly recommended
to make sure that
CH1+2
is muted during setup.
