Lavorwash ASHLEY 800, Manual

Page: 12 / 60

27 The cover of the motor compartment must
only be cleaned with a dry cloth.
29 Service and repairs must be carried out
by qualified personnel only. Only use
manufacturer original spare parts for service
repair.
30 The manufacturer cannot be held
responsible for any damage/injury caused
to persons, animals or property caused by
misuse of the appliance, not in compliance
with manual instructions.
HOW TO PREPARE AND USE THE ELEC-
TRIC ASH VACUUM CLEANER
• (see fig.
①
) Make sure the filter F or G is fitted
in its housing .
• Connect the steel pipe C to its fitting E .
• Before vacuuming the ash, check that it
is cold and no longer alight.
Do not vacuum burning embers
•
Do not empty the drum into a container
which is easily inflammable and make
sure that the ashes are completely cool.
•
If ashes hose C becomes hot during use, turn
the device off immediately and let it cool.
• Turn the appliance on using the (I)ON/(0)OFF
switch, located on the cover of the motor.
• Vacuum the ash directly from the fireplace
or from the stove (wood or pellet-burning).
Hold the suction nozze about 1 cm above
the ash.
• (see fig.
②
) If there should be a reduction in
the suction power, turn the motor off using
the switch and, when the motor is complete-
ly still, operate the filter reset lever T several
times to reset the filter . To do this, pull out
the knob fully and then release it sharply so
that it shakes the filter inside the appliance.
Now, turn the appliance on once again using
the switch and check the suction power. It
is advisable, in any case, to clean a max. of
2/3 Kg of ash (wood or pellets) during each
cleaning operation. Operate the filter reset
lever, before each cleaning cycle.
• When the appliance is no longer in use, turn
it off and take the plug out.
• When the stove or fireplace has been
cleaned, the appliance and suction filter
must then be cleaned .
CARE AND MAINTENANCE
The unit is maintenance-free.
•
The machine shall be disconnected from its
power source, by removing the plug from
the socket-outlet, during cleaning or main-
tenance
• Clean the exterior part of the machine with
a dry cloth.
• Move the appliance only by catching the
carrying handle located on the motor head.
• Store the appliance and the accessories in a
dry safe place, out of the reach of children.
FILTER CLEANING
(see fig.
④⑤
)
•
The machine shall be disconnected from its
power source, by removing the plug from
the socket-outlet, during cleaning or main-
tenance
1- Remove the filter F or G
2- Shake the filter F or G
3- wash tge filter F
4- Let the filter F drying very well ,befor reas-
semble it
•
Once the filter has been cleaned, check
whether it is suitable for further use. If it has
been damaged or broken, replace it with an
original filter.
WARRANTY CONDITIONS
All our machines are subjected to strict tests
and are covered against manufacturing defects
in accordance with applicable regulations. The
warranty is effective from the date of purchase.
The following are not included in the war-
ranty: - Parts subject to normal wear. - Rub-
ber parts, charcoal, filters and the accessories
and optional accessories. - Accidental damage,
caused by transport, neglect or inadequate
treatment, incorrect or improper use and in-
stallation failing - The warranty shall not cover
any cleaning operations to which the opera-
tive components may be subjected, such as
clogged nozzles and filter blocked due to lime-
stones.
This pressure cleaner is intended to be used for
domestic and hobby work: the warranty does
not cover any other different kind of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with
the EU Directive 2012/19/EU on waste
from electrical and electronic equipment and
the national laws of the EU Member States that
12