Lavor Metis, Instruction Manual

Page: 16 / 72

> INSTALLATION AND START-UP
IMPORTANT: The machine installation en-
vironment should be kept at between 10°C and
35°C.
vedi fig.
C
- Connect Steam hose
⑲
to gun and to steam
outlet
⑭
,
- turn up the safety catch fig.
D.
- then open the steam tap
⑮
WARNING: Danger from hot steam.
> FUELLING
DIESEL
(see fig.
A)
18 l
Fill the tank with the fuel indicated on the technical
data plate (Diesel)
In order not to damage the fuel pump, ensure that
the tank never empties while running.
•
WARNING: Use of unsuitable fuel may result in
dangerous situations.
WATER
(see fig.
A)
see section on "WATER SUPPLY"
> TEMPERATURE ADJUSTMENT
(see fig.
B)
Adjust the temperature by means of the thermo re-
gulator
⑪
situated on the control panel.
This machine is equipped with an electronic thermo
regulator to check and adjust the boiler temperatu-
re as well as the pressure from min. 5 bar to max.
10 bar.
- Connect the plug to the power socket.
- When turning the unit on, the display shows the
temperature reading in the boiler.
Adjust the temperature as follows:
- Hold the ( + ) and ( - ) buttons pressed simulta-
neously for a few seconds;
- Press the ( + ) button to increase the temperature,
or the ( - ) button to decrease it.
It is essential that the thermo regulator is set to
190°C in order to be able to work at 10 bar.
TABLE OF COMPARISON BETWEEN DEGREES CENTI-
GRADE AND STEAM PRESSURE EXPRESSED IN BAR
° C bar
152 5
159 6
165 7
170 8
175 9
180 10
•
WARNING:
- The machine is pre-set at the
max temperature of 190 °C.
- For any adjustment, timing
or replacement action not
described in this handbook,
contact qualified personnel at the
manufacturer or resale outlet.
- Adjustments can be made to adapt the machine
to various production requirements.
> STEAM AND WATER OUTPUT ADJUSTMENT
(see fig.
B)
Adjust the steam and water output by using the
two knobs situated on the the left hand side of
the machine
⑦
.
wet steam ; dry steam ;
•
WARNING:
- For any subsequent adjustment, setting or
replacement of parts not foreseen in this
manual, please contact qualified personnel at
the manufacturer or resale outlet.
- Before carrying out any replacement, ensure
that the main switch is in the (0) OFF position.
> START-UP
Description of the start sequence
After carrying out all the connections and preven-
tative inspections described in the previous chap-
ters, start the machine according to the following
instructions:
- Before starting the generator, fill the tanks with
DIESEL up to the set level.
1) Press the main switch situated on the control
panel to the ( I ) ON
⑨
2) Press the BOILER ON button situated on the
control panel to ( I )
⑩
.
EN
16