Laversab ARTS 7000, User Manual, Page: 112 / 194

ARTS 7000 User Manual Aviation Systems
Rev A6 Page 112
3.5. Result Screens Definitions and Indicators - Please note the results indicators in the
right-hand box. The definitions and conditions for these indicators are defined below :
3.5.1. DATA:
Not received : No discernable data information was received.
Received : Valid data has been received and decoded. Data will be
displayed in the left side of the screen
Corrupt Message : Some data has been received but it cannot be decoded.
3.5.2. POWER:
?? : No discernable Power was measured.
XX.XXdBm : A transmission with good power level has been successfully received
and is displayed XX.XX are numeric values for the power attribute.
XX.XXdBM Too Low : A transmission with measurable power has been received but the
level received is too low.
3.5.3. FREQUENCY:
?? : No discernable frequency has been received.
406.XXXMHz : A transmitted frequency has been received and identified. XXX are
numerical values for the received frequency.
3.5.4. Results pages Control Buttons.
3.5.4.1. Discard : Discards the existing test result and performs another test.
3.5.4.2. Re-Test : Saves the existing test result data and performs another test.
3.5.4.3. Exit : Saves the existing test result data and returns the test set to the
start of the ON-Mode Test
3.6. GPS Data.
3.6.1. During the On-Mode test the resulting GPS information (Lat and Lon) may be the
correct position if valid GPS information is available. However, if there is no GPS
data available the result may be blank, indicate last know position or indicate a
default value of LAT 127 degrees and LON 255 degrees.
3.7. Select E XIT to end the test and save the test results.