34
35
How do I dismantle the liquid separator?
1. Pull out the liquid separator. (This may be more difficult with new devices.)
2. Remove the lid by pulling on the lid plunger.
3. Empty the container and clean it with clear water. Then let it dry.
4. Close the lid (don’t forget the rubber seal!) and reinsert the liquid sep-
arator into the vacuum sealer.
6.5 Pressure regulation L+
The Lava pressure regulation L+ allows for precise adjustment of vacuum
strength from -0.2 bar to maximum negative pressure. It is ideal for vacuuming
pressure-sensitive products such as bread, fresh berries, or smoked fish. The L+
pressure regulation can be easily retrofitted for the V.200 Premium X and can be
conveniently reordered from the Lava Shop.
1.
Turn the pressure regulation adjustment screw approximately 3 mm
outwards.
2. Set the selector switch to (Fig. 2, No. 2) and (Fig. 2, No. 7) and
press the device cover down normally.
3. By turning the adjustment screw clockwise or counterclockwise, the de-
sired vacuum can be generated.
4. When the desired vacuum is reached, manually start the welding process .
Tip
If the pressure regulation is fully open, the device’s flap does not
hold on its own. Therefore, it can happen that the welding seam is
not perfect. To avoid this, apply increased pressure on the device’s
flap during the vacuuming and welding process. To achieve a per-
fect welding seam, the adjustment screw on the pressure regulation
L+ can be turned clockwise approximately 1 second after the weld-
ing process has started. This will prevent any more air from being
sucked out of the bag and the device’s flap will close tightly.
Further instructions for vacuuming pressure-sensitive products can be found
in chapter 7.5, page 40.
7. Operation
This chapter contains important instructions for operating the vacuum sealing
device. Please read the following instructions carefully to avoid any damage.
Attention: Never use foils that are not explicitly intended for vacuum sealing.
The best results are achieved when using structured Lava vacuum bags or rolls.
Tips for using smooth bags can be found on page 36 under “Vacuum sealing
smooth vacuum bags”.
Lava vacuum sealers only work properly with original Lava vacuum bags and
rolls. These can be purchased directly from the online shop at www.la-va.com
or through the ordering hotline: +49 7581-90430
7.1 Vacuum sealing in bags
1. Connect the device to a 230-volt power outlet and turn on the ON/OFF
switch (Fig. 2, No. 1). The selector switch will now light up, indicating that
the device is ready for operation.
2. Set the desired welding time (see 6.3) on the control knob.
3. Open the device cover.
4. Set the device on the container/bag selector switch (Fig. 2, No. 2) to
and select the manual or automatic
mode (Fig. 2, No. 7) as
needed. Place the food in the bag.
5. Fill the bag up to two-thirds full and make sure that the edge of the bag
does not get dirty.
Tip
Fold the edge of the bag outward before filling it with food. Fill the
food into the bag and then fold the edge back in. This way, the
food does not come into contact with the bag’s edge where the
seal is made.
EN
