14
technical documentation that accompanied your
gateway/router.
Every TCP port that is accessible externally MUST be
unique and may not be shared between multiple internal
targets.
Certain gateways may allow for port redirection (i.e.
Any external available TCP port may be redirected to any IP
address and TCP port on the network). If however your gateway
doesn't support port redirection, then all external TCP port
connections will need to be matched to the exact same internal
TCP port number. As a result, if you wish to make multiple
devices accessible over the gateway/router then you will be
required to reconfigure the
to prevent
multiple
s from using the same TCP port
numbers.
8. Open the LAVA
and click on the "WAN
Activation" button, located on the main toolbar. The "WAN Port
Settings" window will open.
9. Enter the IP address of the gateway and the externally
accessible TCP port of the first port you wish to create the WAN
activation on, then click OK.
10. A new COM port will be created that you can configure and
connect to as you would a standard
COM port
activation. To verify this simply click on "My Computer" in the
LAVA
. In the right hand pane you should
find a new port "LAVA Ether-Serial Port (COMXX)" resembling
the WAN activation icon.
11. Repeat step 9 for any additional WAN activations you wish to
create.
New versions of Ether-Serial Link software and firmware may be
found at www.lavalink.com.
Ether Link Manager
Ether Link Manager
F. Upgrading Software
NOTE 1:
NOTE 2:
Ether-Serial Link
Ether-Serial Link
Ether-Serial Link
