12
E. WAN activation
Activating an Ether-Serial Link on a WAN is be done in two
different ways, depending on the network location of the
:
•
located externally –
is
directly accessible on the Internet.
•
located internally –
is
located behind a gateway or router and is not directly
accessible.
All steps assume the Ether-Serial Link has already been
configured and is working on a public IP address.
1. Obtain the IP address of the
2. Open the embedded web page of the
from
your browser by typing in its IP address in the address bar.
3. Ensure that the port(s) to create the WAN activation on are
configured for "Driver Mode".
4. Record the TCP port number of the port(s) to be accessible.
5. Close your browser.
6. Open the LAVA
and click on the "WAN
Activation" button, located on the main toolbar.
7. This will open the "WAN Port Settings" window.
8. Enter the IP address of the
and the TCP port
number of the first port you wish to create the WAN activation
on, then click OK.
9. This will create a new COM port that you can configure and
connect to as you would a standard
COM port.
Verify this by clicking on "My Computer" in the LAVA
In the right hand pane you should find a new port
titled "LAVA Ether-Serial Port (COMXX)" resembling the WAN
activation icon.
Configuration & installation when Ether-Serial Link is external:
Ether Link Manager
Ether Link
Manager.
Ether-
Serial Link
Ether-Serial Link
Ether-Serial Link
Ether-Serial Link
Ether-Serial Link
Ether-Serial Link.
Ether-Serial Link
Ether-Serial Link
Ether-Serial Link
NOTE: