LAUNCH
Tyre Changer (TWC-401NIC)
6
making the lower tyre bead fall into the rim groove
completely.
z
If a tube needs to be installed in the tyre, check first
for the possible damages. Round it onto the rim.
Make sure to keep the tube in the right position
throughout the mounting process.
z
To install the upper tyre bead, place the tyre well and
readjust position of the tyre bead (same as mount of
the lower tyre bead in Fig.17. Press down the tyre
opposite to the mount/demount head to the rim
groove (Fig.18)).
Fig.17
Fig.18
z
Depress the pedal J (Fig.12) to turn the turntable
while keeping pressing on the tyre. When only
10~15cm is left, slow down to avoid damage of the
tyre bead. Stop the motor if there is any indication
for damage. Lift the pedal J and turn the turntable
counter-clockwise. Try again when the tyre is back
to the original shape.
Note:
It is not necessary to move the handle of the
screw every time if the size of rim matches the
tyre. Just move the swing arm.
In the process of operation, keep head and
hands away from the area between the tyre and
the swing arm to avoid injury.
Inflating tyre
Danger!!
Inflating can be highly dangerous. Take precautions
and pay close attention to the procedures. Check if
the compressed air is well connected before inflating.
Inflating procedures are shown in Fig.19. The machine is
equipped with a gauge to read the pressure in the tyre.
z
Loose the wheel on the turntable.
z
Connect the outlet of the gun to the air inflation
valve.
z
Slowly press the switch on the inflating gun for
several times during inflation to make sure that the
reading on pressure gauge meets the
manufacturer’s specifications. The pressure
should not exceed 3.5 bar.
z
If the pressure exceeds the limit, press the button on
the gun inflator so that the pressure goes down to
what is required.
Caution: Danger of explosion!
The safety procedures should be closely followed.
Review and abide by the following instructions.
Otherwise serious injury or death can be resulted.
The manufacturer shall not be held responsible for
any possible accident when the safety procedures are
not followed.
Carefully check the dimensions of rim and
tyre to see if they match each other. Check
and make sure that the tyre is not worn or
damaged before inflation.
When a high pressure is required, remove the
tyre from the tyre changer and resume the
inflation in a special protective hood.
Be careful when inflating the tyre. Keep
hands and the rest of human body away from
tyre
.
Fig.19
