Lauda MC 250, Operation Instructions Manual

Page: 8 / 64

1.6 Requirements for the heat transfer liquid
n
Heat transfer liquids are used for temperature control. Only LAUDA
heat transfer liquids are approved for use in the device. LAUDA heat
transfer liquids are tested and approved by
LAUDA DR. R. WOBSER GMBH & CO. KG
n
In each case, the heat transfer liquids cover a specific temperature
range. This temperature range must match the temperature range of
your application.
n
The use of heat transfer liquids can cause hazards arising from high and
low temperatures, and fire, if certain temperature thresholds are
exceeded or if the temperature falls below the threshold value, or if the
container breaks and there is a reaction with the heat transfer liquid.
n
The safety data sheet specifies the hazards and appropriate safety meas-
ures for handling the heat transfer liquid. The safety data sheet of the
heat transfer liquid must therefore be consulted for the intended use of
the device.
1.7 Materials
All parts coming into contact with the heat transfer liquid are made of high
quality materials suitable for the operating temperature. Stainless steel and
temperature-resistant plastics are used.
1.8 Requirements regarding the hoses
Only LAUDA hoses must be used for the external hydraulic circuit. LAUDA
hoses are hoses approved by LAUDA DR. R. WOBSER GMBH & CO. KG.
Particular attention must be paid to the permissible temperature range and
the maximum permissible pressure when selecting suitable hoses for the
application.
1.9 Application area
The device is exclusively permitted to be used in the following areas.
n
Commercial area
n
Indoor use, no outdoor installation
1.10 Personnel qualification
Operating personnel
Operating personnel are employees that have been instructed by technical
staff in the intended use of the device according to the operating manual.
V05REV08 Microcool 8 / 57