Step By Step Instructions
Numbers in parenthesis refer to hardware shown on page 3.
Attaching the Ropes to the
Rope Reel
Attach the rope to the rope reel. Guide the
ropes onto the rope reel while operating
the key switch in the cover pos
i
tion.
Tip: The rope for the non-motor side should
be attached approximately 1 inch further
down than the motor side rope depending
on the width of the pool. Use the switch
and operate the cover in the “Closed”
position to cover the pool.
Pinning the Cover to the
Roll-up Tube
Using a self-tapping screw (42), attach the
bonding wire on both sides of the roll-up
tube.
23
20
Find the center of the slack and pin directly
to the tube (DO NOT FOLD THE SLACK).
Repeat this step several times along the tube.
This will help to dis
tribute
the slack across
the roll-up tube evenly.
Tip: Use the weld line on the tube to help pin
the cover straight on the tube.
Make sure that the cover and the webbing roll
up nice and even around the roll-up tube.
Operate the cover 6-10 times to and make any
adjustments to the rope reel brake and roll-up
tube brake if necessary.
The CS300HD installation is complete.
19
21
22
Using a self
-
tapping screw (32), line the cover
up straight as it comes out of the track and pin
the cover to the roll-up tube on both sides
.
© Latham Pool Products, Inc. 2018. All rights reserved.
16 of 19
