![background image](http://html1.mh-extra.com/html/latham/cs3000lo/cs3000lo_installation-manual_679349010.webp)
Step By Step Instructions
Numbers in parenthesis refer to hardware shown on page 3.
Assembling the mechanism
Turn the motor and non-motor end upside
down. This is done to appropriately attach
the roll-up tube and the mechanism
mounting feet.
Attach the roll-up tube to the non-motor end
of the mechan
i
sm using the 3/8” x 1
-1
/4”
bolts (44) and lock washers (50) provided.
To attach the feet, first measure the distance
from the bottom of the cover box to the
bottom of the track.
(This will determine the height of the
mechanism.)
Attach the mechanism feet to the
mechanism approximately 1 inch less than
the distance from the bottom of the cover
box to the top of the track/retainer. Use a
7/16 inch ratchet to tighten bolts.
Tip: The roll-up tube should be set as high
as possible without allowing the cover rub
on the lid brackets.
Installing the mechanism
in the
C
over Box
Line up the mechanism with the track so
the rope will come straight out and around
the motor end pulley.
Center the tube in the cover box. Tip: If the
pool is not square, square up the mechanism
with the track.
Attach the mechanism feet to the floor of
the cover box. Use the mounting hardware
provided.
1
2
3
4
5
6
7
8
9
Loosen the four nylock nuts on the pulley
brackets. Raise the pulley bracket assembly
so it is level with the bottom of the track.
Attach the roll-up tube to the motor end of
the mechan
i
sm using the 3/8” x 1
-
1/4”
bolts (44) and lock washers (50) provided.
© Latham Pool Products, Inc. 2018. All rights reserved.
10 of 19