Position the fabric on the leading edge so it is
in line with the leading edge support bracket.
Secure with a tek screw (40) on the back side
of the leading edge. Be sure the screw does
not interfere with the leading edge insert.
Attaching
t
he Ropes
t
o
t
he Reels
Pull the cover back until the cover is in the
track equally on both sides. Pull the ropes
tight as they come off the pulleys on the
mechanism to eliminate the slack in the rope.
Note: Cut the ropes only when the cover is
open completely.
27
Feed the wheel assembly and cover into the
track. The slider on the front of the wheel
assembly will lock into the track.
Place a guide feed (23) over the end of the
track. Use a 3/16” drill bit to drill through the
guide feed. Feed the wheel assembly and
cover into the track.
Use a 5/32” allen wrench to tighten the
screw on the guide feed.
Place a bonding wire lug (31) on top of the
guide feed and secure with a 10-32 1-3/8”
screw (46) and nylock nut (36).
Run the #8 copper bond wire (29) from the
lugs on the guide feed to the lugs on each
end of the mechanism.
19
20
21
23
24
Connect the bonding wire that is attached to
the front corner of the cover to the leading
edge bar using a tek screw (40). Be sure the
screw doesn’t interfere with the leading edge
insert.
26
Install a track stop (47) on the end of the
track on each track to keep the cover from
retracting too far. Run the key switch in the
uncover position to roll the cover up on the
roll-up tube. Check the cover to be sure it
rolls up evenly. The cover fabric installation
is now complete.
22
25
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Numbers in parenthesis refer to hardware on page 3.
Step By Step Instructions
16
