Rolling Out
t
he Cover
Standing behind the housing looking over the
pool, unroll the cover from left to right.
Unwrap the ropes and run them through the track.
Running Ropes Through
t
he
Guides
The preferred method of running
the rope is to pierce the rope with a 1’ length
of wire and use it as a handle to feed the rope
through the track.
Hold the wire with some pliers and pull the
rope down the length of the track toward the
end of the pool.
Feed the rope through the pulley assembly
(26) and place the pulley housing onto the end
of the track.
Feed the rope into the back channel then
pull the rope down the back side of the
track toward the cover housing.
Pull all excess rope through the cover track.
2
3
4
5
6
7
8
9
Step By Step Instructions
Complete the fastening of all track screws
flush to the top of the track and fasten the
pulley screw on both sides of the pool. Clean
concrete dust from track and pulley endcap.
Make sure
ALL
screws are flush with track.
Opening
t
he Cover
To open the cover box, cut the bands that hold
the two halves of the box together. Never cut
the top of the box open. Doing this could
easily damage the cover inside. This kind of
damage is not covered under the fabric
warranty. With the bands cut, lift and remove
the top box.
1
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Numbers in parenthesis refer to hardware on page 3.
14
