Numbers in parenthesis refer to hardware on page 3.
Position the mechanism in the housing so
that the roll-up tube is centered between the
track and centered in the housing front to
back.
Align the mechanism on the motor side first
by using a straight edge or a piece of rope
and extending it from the back channel of
the cover track to the pulley #1 to make sure
the rope is running straight into the pulley at
a 90 degree angle.
Go to the non-motor end and make sure the
rope will come straight back from the back
channel of the track to the pulley. If the ropes
do not come straight back, the mechanism
should be moved to balance the rope angle on
both sides. Only a 1/2” variance from straight
is allowed on either side.
Extending
t
he Pulley Brackets
Extend the pulley brackets. Loosen the nuts
on the pulley brackets and spread the
brackets outward against the walls of the
housing.
Note:
Do the following steps on Motor and
Non-motor end (motor end shown).
Raise the pulley bracket up so that the top
of the bracket is even with the top of the
housing.
Note:
If you will be using the Flat Lid 309
Kit (A2432) the mechanism will need to be
installed 1-1/8” below deck height.
With the brackets in position, level the
mechanism and center it in the housing from
front to back. Tighten the four nuts on the
adjustable brackets.
10
11
12
14
15
18
Anchoring Mechanism
Anchor the mounting feet on both the motor
and non-motor ends into the housing using
as many anchor points as possible.
16
Now loosen the bolts and spread the pulley
brackets at the non-motor end making sure
they are also level. Raise the pulley bracket so
it is flush with the top of the encapsulation.
Anchoring
t
he Pulley Brackets
Anchor the brackets in to the housing in as
many places as possible using the 1-1/2” hex
head screws (49) and anchors (39).
Note:
Do the following steps on Motor and
Non-motor end (non-motor end shown).
18
13
17
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Step By Step Instructions
11
