Lastec Articulator 325D, Owner'S Manual, Page: 35 / 48

Initial Set-Up
Pre-Operation Equipment Inspection Checklist
Initial Set-Up 325D/425D/Odoc082200 3-19
3
3.31 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection prior to each operation of the Articulator.
q
Verify that the parking brake is set.
q
Check the fuel level.
q
Verify that the fuel shut-off valve (between the fuel tank and the fuel filter) is in the ON position.
q
Check engine oil level and condition.
q
Check the air cleaner and filter elements for contamination or debris.
q
Brush out and clean the radiator and hood grills.
q
Check coolant level & condition in overflow tank.
q
Check hydraulic fluid level and condition. Add if low - do not overfill. Change oil & filter if necessary.
q
Inspect the entire hydraulic system for leaks.
q
Adjust hydrualic pumps if needed.
q
Check both hydraulic pump belts and tension springs for proper installation, tension and condition.
q
Check the gearbox oil level and condition.
q
Check entire area around and under gearbox for oil leaks.
q
Check the gearbox belts for proper tension and condition. Proper tension is 70 FT LBS. Use LasTec
V-belt tension gauge Part No. 028498 ONLY.
q
Check the mower deck drive belt and idler tension spring for proper installation, tension and condition.
q
Clean entire mower deck area under operator seat pan of any grease, oil, fuel, grass, or debris.
q
Check all mower deck belts and idler tension springs for proper installation, tension, and condition.
q
Clean each deck under the belt covers of any grease, oil, fuel, grass, or debris.
q
Inspect weight transfer springs for proper installation and function.
q
Inspect all blades for proper installation, orientation, tightness, sharpness, and overall condition.
q
Be sure the seatbelt is secure and operable.
q
Adjust the operator seat for proper operator position.
q
Check that both steering controls arms are properly linked, free of debris, and operating freely.
q
Test the function of the headlights and hazard lights.
q
Set the mower deck height to the desired level.
q
Calibrate the mower deck height cables if needed.
q
Check the air pressure in the pneumatic drive tires. (10 PSI.)
q
Check the air pressure in the pneumatic front tires. (20 PSI.)
q
Check the air pressure in any pneumatic (non-urethane filled) gauge tires. (50 PSI.)
q
Verify proper function of all gauge wheels.
q
Verify that all warning decals are in place, visible and legible.
q
Verify that all covers and safety devices are properly installed and secure.
q
Check that the discharge chute is clear of debris, properly mounted, and in good condition.
q
Inspect entire Articulator for loose or entangled parts, debris, obstructions, or neglected tools.
q
Verify that the battery has sufficient charge to start the engine.
q
Check engine for abnormal exhaust or sounds.
q
Check oil pressure and coolant temperature lights.
q
Check the hydraulic and/or manual mower deck lift arms for proper lifting and locking operation.
q
Be sure the operator seat pan & engine cover are properly closed, latched, and secure.
q
Record the hour meter setting if desired.
q
Complete the appropriate maintenance checklist (section 5).
Go to www.lastec.com for latest changes in this manual.