Laski VD 500, Operating Instructions Manual

Page: 8 / 39

8
o
Before transport put the suction hose in its holders around the machine to
avoid its overhanging in side face. Keep the given traffic rules and instructions
for vehicle outlines and lights.
o
Before transport fix the discharge duct hose against motion.
o
Couple the exhauster to a towing vehicle properly and check its proper
coupling.
o
Plug and check traffic lights of the exhauster.
o
Keep the chassis always in good technical condition.
o
Do not endanger other people within the reach of the machine.
o
Check materials to be sucked and remove all undesirable objects. If you see
such particles being rejected, stop working immediately.
o
Keep work safety instructions given in manuals of transport means.
-
This manual describes problems and faults which could occur at work and
which may be remedied by an instructed person. In case of other problems and
faults do not hesitate and contact the manufacturer. He is always ready to help
you.
- Never do any technical changes or actions which are neither given in this
manual nor allowed by the manufacturer. The machine, not correctly installed
or adjusted, may run without problems now but in the future it could damage
any of important parts.
- Do not put any objects or tools on the machine.
- Do not use the exhauster for transport of persons or things.
- The manufacturer does not bear responsibility for any damages or injures to
the third persons or to other equipment resulted from disobedience to
instructions given in this manual.
- When handing the machine over to another person make sure if all controls,
guards and other safety elements are complete.
- Do not remove guards and other safety elements. They serve for your safety.
- Keep the given intervals for checks of bolted joints.
- Always after work clean all parts of the machine with pressure water.
- Some parts of the machine can be hot while in operation. Avoid any settling of
flammable leaves and similar materials on such parts or close to engine intake
openings, fuel tank and exhaust manifold. Stop working if such dangerous
deposits occur.
- Any servicing can be done only if the machine was put out of operation and its
battery was disconnected.
- Avoid any random start - disconnect the plus pole of the battery.