User Manual: V PRO-OEM
Stand: 03/2010
Page 5 of 8
6
Pattern
0~255
160/5=32pcs
7
Horizontal rotation
0~255
slow to fast
8
Vertical rotation
0~255
slow to fast
9
Rotation about Z-axis
0~255
slow to fast
10
Horizontal movement
0~255
slow to fast
11
Vertical movement
0~255
slow to fast
12
Horizontal size
0~255
slow to fast
13
Vertical size
0~255
slow to fast
14
Hor. and vert. size
0~255
slow to fast
15
Drawing speed
0~255
slow to fast
16
Point draw
0~255
slow to fast
17
Scanspeed
0~255
slow to fast
18
Pattern size
0~1
Original size
2~255
Size (120=original)
Maintenance / cleaning
Always disconnect from mains before cleaning/opening the laser. Regularly clean the interior
from dust, especially ensure operation of the fans. Use a sponge with alcohol, rather than
wet cloth or other chemical liquid, to clean the mirrors. Be careful, even light scratches
reduce the output power of the laser. Mirrors need cleaning, when a “halo” is noticeable
around the beam, or an unusual high amount of diffuse light can be seen inside the device.
Technical specifications
•
Modes:
ILDA, DMX 512, auto, music active
•
ILDA:
25pin ILDA standard Sub-D shaped 25pin connector
•
Galvos:
50k scanspeed
•
DMX 512:
14 channels
•
Patterns:
160
•
Scanangle:
set to ca. 40° optical (60° max)
•
Beam:
ca. 3mm/1mrad
•
Accessories:
power cable, key switch, interlock plug, manual, safety cord
•
The laser comes in a flightcase.
•
Input voltage:
AC 100~240V 50/60Hz
•
Power consumption:
450W
•
Size:
670 x 370 x 440 mm (W x D x H)
•
Weight:
30kg Laser,
total:
50kg
(with
flightcase)
•
Operating temperature:
10°-35°C
(below 20°C the power may be reduced)
Change scanner
1.
Unscrew UK M6 screws and disconnect signal
cable.
2.
Loosen M4 x 10 screw and remove galvo.
3.
Insert galvo, reconnect and fix signal cable.
4.
Rotate galvo to centre projection. Fix galvo.
Adjustable mirror mounts
1.
Loosen setscrews, then adjust with X/Y
adjustable screws. Make sure beam is centred
on scanner mirrors.
2.
Adjust Z-screw simultaneously.
3.
Tighten setscrews.
