Manual: Purelight PL-16.000RGB compact CT / PL-31.500RGB compact CT / PL-16.000G compact CT / PL-32.000G compact CT
Manual: Purelight PL-16.000RGB compact CT / PL-31.500RGB compact CT / PL-16.000G compact CT / PL-32.000G compact CT
page 6 / 19
page 7 / 19
6. Warnings and other notices on the device
Laser radiation!
Avoid exposure
to beam.
Laser class 4
Caution of
radiation if cover
is removed
power supply
& consumption
model type
wavelength
Output power
production
year
Please read manual before operation
7. Device connections
ILDA out
ILDA in
connection for power
supply
Indicating LEDs for
power, overheat &
interlock
trim pots for co-
lor adjustments
trim pots for
x / y shift
8. Operation
1. Please
notice:
Always connect the device to the power supply first before connecting it to the grid.
Make sure that your device is provided with the correct voltage. Wrong voltage could lead
to irreparable damages. Please find the correct voltage data in the synoptical table at the
end of this manual. It must be ensured that the device is not directed to people or inflam
mable objects during installation.
The “Power“ diode on the rear side of the device begins to light up after the device has
been connected to the power supply.
2. ILDA in / ILDA out
The device can be controlled via ILDA control signal. There are a ILDA-in (ILDA in-
put) and a ILDA-out (ILDA output) interfaces on the rear side of the device.
Connect the laser system to the control interface (DAC) by using an ILDA cable. Do not
connect the laser to standard parallel port at your computer, but always use an appropri-
ate ILDA interface (usually is sold together with the laser control software). After that you
are able to control your laser by a showlaser software (e.g. Phoenix or Pangolin). Use the
ILDA-out interface to daisy-chain the signals (from ILDA-in) to a further device.
3. X/Y Axis
There are two trim pots for X and Y axis adjustments on the rear side of the unit. Use the
X-Axis pot to vary or to glean the picture along the x-axis. Use the Y-Axis pot to vary or to
glean the picture along the Y-axis. Avoid that both pots are set to centerposition at the
same time. Otherwise the power density of the beam gets extremly high! (You can avoid
this by activating the safety with beam block.)
4. Colors
The trim pots Red, Green and Blue on the rear side of the device can be used to adjust the
single colors in their color balance.
Red:
Turn the „Red“-pot to adjust the red color balance.
Green: Turn the „Green“-pot to adjust the red color balance.
Blue:
Turn the „Blue“-pot to adjust the red color balance.
5. Overheat
Find the “Overheat“-LED below the “Power“-LED on the rear side of the device. By de-
fault the unit has an integrated protection against overheating. To avoid overheating,
the overheat control reduces the output power without switching the device off. If the
temperature of the device (not air temperature) becomes to high, the overheat LED lights
up and the output power of the device gets reduced. Please improve ventilation if the
Overheat LED lights up
.
