Checking Parts
Please make sure the following parts are included:
1 x Laser projector
1 x Remote lock connector
1 x key
1 x Power cable
1 x User manual
Safety instructions
If the device has been exposed to great temperature changes,
do not switch it on immediately. Condensation water may
damage your device. Leave the device switched off until it has
reached room temperature.
The laser must only be used for shows. Any operation has to be attended and supervised by a skilled and
well-trained operator.
Never leave this device running unattended and keep it away from children and unauthorized persons.
Keep away from heaters and other heat sources. In order to safeguard sufficient ventilation, leave 50 cm of
free space around the device.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: If you open the device for cleaning, always disconnect from mains!
HEALTH HAZARD! Never look directly into the light source, as sensitive persons may suffer an
epileptic shock!
These lasers are considered a definite eye hazard, particularly at the higher power levels, which WILL cause
eye damage. So these laser series models supplied with a key switch to prevent unauthorized use, warning
labels and aperture labels affixed to the laser.
Installation safety
Prior to installation and operation of the laser, the paths of the beams and effects should be considered,
particularly with respect to how they will reach the audience. If direct audience scanning is desired, then
the laser energy in the effects needs to be considered to decide if the effects are safe for direct viewing.
Always ensure, that the maximum permissible exposure (MPE) is not exceeded in the area accesible to the
public. So install the laser in such a way, that minimum distances and heights ensure the MPE is never
exceeded in the public area. When audience scanning is performed, an operator has to be present. An
easily accessible emergency switch has to be installed. When setting up the laser, make sure the laser is
affixed firmly, to avoid vibrations.
Warning labels on the device
Laser radiation
Read manual
before use
Avoid exposure
Operation by qualified
To the beam
personal only
Laser class 3b
Never direct laser
Beam at people
Caution of radiation
Never look directly
If cover is removed
into beam
Indoor use only
At front opening:
Avoid exposure – laser radiation is emitted.
INSTALLATION/OPERATION
Don’t remove the warranty/serial number label - removal voids warranty
The operator has to make sure that laser radiation – for laser class 4 also reflected laser radiation – higher
than the maximum permissible level is avoided by technical or organisational measures. (Especially with
respect to the MPE, see above.)
Make sure to use the correct voltage. Use a power socket with earth/ground.
Don’t use dimmer, RC,
or
other
electronically switched
sockets. Whenever possible, don’t use the laser together with large
appliances, especially fog machines, on the same mains!
If the device is used in a flying installation, the mounting brackets and an appropriate safety-rope must be
afixed.
In some countries, the operator must notify the accidence insurance and the authority for industrial safety,
before operating a laser. For more information, contact the relevant authorities.
Please consider that unauthorized modifications on the device are strictly forbidden due to safety reasons!
If this device will be operated in any way differently than described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like
short-circuit, burns, electric shock, etc.
