Manual: CS-2000RGB FX
EN page 10 / 11
•
ILDA control:
Connect your device („ILDA IN“) via an ILDA cable to an
interface / controller. Use a laser control software, to run the device. Use
„ILDA OUT“ to connect it to another device.
In ILDA mode all DIP swit-
ches should be switched off.
•
Master-Slave-Mode:
To use the daisy chain / Master-Slave-Mode connect
two (or more) laser projectors of the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector :2 ...etc.
DMX setting at the
slave projector:
DMX cable
Slave projector
Master projector
Choose stand-alone or
sound-to-lightmode at
the master projector
(see above)
8.
To turn off the device switch it off („OFF“), switch the key to „OFF“ and
disconnect the power cable from the mains.
9.
Close the beam block shutter to prevent laser output: Loose both screws
and slide the shutter in front of the window. Tighten the screws again. Do
it conversely to open the beam block shutter.