Quadrum / Quadrum Green
25
Y
Z
X
X
X
Y
Y
Y
Y
X
X
Y
Y
X
X
Regularly check the adjustment before
use, after transport and after extended
periods of storage. Always make sure
to control all axes.
!
Adjustment mode
Take the alignment of the rotary laser into account when perfor-
ming adjustment work. Always adjust all the axes.
X axis adjustment
Activate adjustment mode: Switch on the Quadrum. Press the Y axis
plus/minus buttons simultaneously until the auto/man. LED flashes.
Adjustment: Use the X axis plus/minus buttons to move the laser
from its current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Press the Y axis plus/minus buttons simultaneously until the
auto/man. LED goes off.
Adjust the Y and Z axes
Activate adjustment mode: Switch on the Quadrum. Press the X
axis plus/minus buttons simultaneously until the tilt LED flashes.
Adjustment: Use the Y axis plus/minus buttons to move the laser
from its current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Press the X axis plus/minus buttons simultaneously until
the tilt LED goes off.
To adjust the Z axis, set up the device vertically
and proceed in the same manner as for the Y
axis adjustment.
X- / Y- /
Z-Axis
GB
Summary of Contents for Quadrum
Page 134: ...134...
Page 135: ...135 Quadrum Quadrum Green...
