55
USER PROGRAMMABLE FUNCTIONS DESCRIPTION
USER PROGRAMMABLE FUNCTIONS DESCRIPTION.
ACOUSTIC SIGNAL ARM DISARM
:
The product at the closure via original radio command of the vehicle emits two acoustic signals.
In arming 2 beep and for disarming 1 long beep. This sounds can be removed
ACOUSTIC SIGNALING AT ARMING:
The product at the closure via original radio command of the vehicle emits two acoustic signals.
At disarming there will be no acoustic signal if the product has not detected break-ins in the time
it was armed if it detects break-ins , it emits a short beep to signal the alarm.
The procedure allows to remove the beep at disarming with the original radio command.
DOOR CONTACT LIGHT BLUE WIRE I TRIGGER
tThis setting allows you to change the negative door alarm command input to the door alarm
input with the function of blocking the deactivation of the alarm in the presence of the signal
(setting to be made on vehicles with traditional activation and deactivation commands and only
on indications specific techniques).
DIRECTION INDICATOR ONLY IN ALARM CYCLE (yellow and yellow-red wire)
:
this option allow to exclude the blinked command send by peripheral of the direction indication
at the closure ( 2 blink) and at open (1 long blink).
So that the opening and closing flashes remain such.
the procedure allow to escluded the direction indicator signalation at arming and disarming of the
product.
IGNITION KEY SIGNAL DETECTION FROM CAN-BUS/ LIN:
The product (depending on the model) detect via can bus line the state of the vehicle on,
causing an alarm condition.This signal can be excluded for prevent fake alarm
DETECTION OF DOOR SIGNALS FROM CAN-BUS / LIN:
The product detects the opening status of one of the doors via the data network, causing an
alarm condition. This signal can be excluded if necessary .
DETECTION OF BONNET SIGNAL FROM CAN-BUS / LIN:
the product detects the opening status of the bonnet via the data network, causing an alarm
condition. This signal can be excluded if necessary.
DETECTION OF TRUNK SIGNAL FROM CAN-BUS/LIN:
The product detects the trunk opening status via the data network, causing an alarm condition.
This signal can be excluded if necessary.
RESTORE FACTORY SETTINGS
This setting is programmale only in ON for make the rest parameters set
It also allows you to restore the only user functions.
The function does not change the veichle model set previously.
