ULTRASONIC SENSORS CALIBRATION
VERIFICATION OF KIT OPERATION
1- Lower the glass of one of the front doors.
2 - Make adjustment to an average sensibility of the ultrasonic module.
3 - Press the button on the transponder verifying the alarm arming with a short double acoustic
signalling (beep) of the siren.
4 - Introduce an arm and shake it verifying that the system goes into alarm
. The
after about 2 seconds
siren then must start to play strong.
If this doesn’t happen is necessary to increase the sensibility and repeat the operation:
Clockwise: maximum sensibility;
Counterclockwise: minimum sensibility.
Counterclockwise until the end of the race: deactivated sensors.
5 - To disarm the system and stop
the alarm condition press again the transponder button verifying
so
that the siren stops to play strong after
it gives out
acoustic signalling (beep)
that
3 shorts
.
NOTE:
Wait about one minute after the alarm arming, before adjust the sensitivity, to obtain a better
regulation.
PAG. 27
Summary of Contents for LA251
Page 32: ......
