ALARM AUTO-DIAGNOSTICS
If an alarm was generated while the system was armed, when the system is disarmed the direction
indicator lights will flash briefly (½ second) and an audible tone will be produced to indicate that an
alarm condition has occurred. At any time while the system is disarmed and the ignition key is off,
you can check the alarm memory by pressing buttons A and B on the remote control at the same
time. By looking at the LED installed on the dashboard, you can determine which circuits generated
the last 5 alarm conditions. The LED will begin flashing and the sequence of flashes will identify the
relative sensor:
Attention:
Ø
The causes of the alarm will be displayed in sequence from the last to the fifth. At the end of
the display, to repeat the five codes press both buttons again on the remote control.
Ø
After
checking the flash codes, the memory will be cleared when the alarm is next armed.
LED OFF:
no alarm conditions have occurred
2 FLASHES/PAUSE:
the ULTRASONIC sensor generated an alarm condition
3 FLASHES/PAUSE:
the DOOR/HATCH sensor generated an alarm condition
4 FLASHES/PAUSE:
the BONNET sensor generated an alarm condition
5 FLASHES/PAUSE:
the IGNITION KEY sensor generated an alarm condition
6 FLASHES/PAUSE:
the POWER SUPPLY sensor generated an alarm condition
7 FLASHES/PAUSE:
the BOOT/ADDITIONAL sensor generated an alarm condition*
8 FLASHES/PAUSE:
the GARAGE sensor generated an alarm condition*
9 FLASHES/PAUSE:
FLAT REMOTE CONTROL BATTERY
10 FLASHES/PAUSE:
FLAT INTERNAL BATTERY AUTO-POWER SUPPLY (290i2/291 only)
DIAGNOSTICS FLASH CODES
ISUT291-213UK.p65
11/05/2006, 18.53
10
