ADDITIONAL SIREN (290i2/291 only)*
This function allows the alarm to be connected to an additional siren/vehicle horn/paging system
and can be programmed to obtain a continuous or intermittent output for the entire alarm cycle.
TYPE OF SOUND (290i2/291 only)*
Two different types of sound can be programmed: monotone or modulated (manufacture default to
monotone).
SIREN EXCLUDING
Disarm the alarm system using the remote control. Enter the vehicle and make sure that all doors/
bonnet/boot are closed. Turn the ignition key ON; within 5 seconds press button “B” of the remote
control once. At the same time that you press button ”B”, you will hear a brief audible tone to
confirm the programming. Now the siren sound is temporarily excluded and if an alarm condition
occurs, only the direction indicator lights will flash. This function may be necessary in hospital
parking areas, ferries, skiing resorts etc.
The function will be reset the next time the alarm is armed using the remote control or an
electronic key.
ATTENTION
: excluding the siren does not deactivate the additional siren/vehicle horn/paging
system and the panic function.
FLAT INTERNAL BATTERY POWER SUPPLY SIGNAL (290i2/291 only)
If your alarm system is equipped with an internal battery, it can automatically check the battery
charge and charging circuit. In case of a malfunction, the system communicates the problem to
you through the “
Alarm auto-diagnostics
” function by flashing the LED 10 times.
IMPORTANT NOTE
: Only to be used if the car is equipped with an original “
crash sensor
”
(inertia switch) power locking system that is activated if an accident occurs. If not, a similar one
available on the market must be installed. Laserline S.p.A. will be not be held responsible if users
do not comply with this note.
KEY
* Optional. ** Vehicle dependent.
ISUT291-213UK.p65
11/05/2006, 18.53
13
