pag. 12
ENGLISH
If your original remote control/electronic key does not work correctly or has been lost, to disarm
the alarm system and enter the alarm into garage function (see section 8) you must insert the
“emergency pin code”
by doing the following:
Œ
With the alarm armed, activate the siren by opening the door on the driver’s side;
•
Enter the vehicle. The alarm will stop sounding after 30 seconds and then the LED installed on
the dashboard will illuminate for 5 seconds. Within the 5 seconds, turn the ignition key ON
and OFF for 1 second;
Ž
The LED in the receptacle will start to flash and the alarm is ready to accept the Pin Code. If
not interrupted, the LED will flash 10 times. Wait for the flashes corresponding to each digit of
your Pin Code to be displayed, then turn the ignition key ON and OFF for 1 second
only after
the LED is off
. Read Pin Code at the end of these instructions from left to right. See the follow-
ing example:
•
now remove the electronic key.
With garage function enabled the alarm will flash the red LED in the receptacle every 15 seconds to
indicate garage mode. If the optional immobilisation relay is fitted to the vehicle with the optional
passive functions enabled, these function will be disabled allowing the vehicle to be driven.
To disable the garage function:
Œ
turn on the vehicles ignition key and keep it turned on;
•
insert an electronic key into the receptacle socket;
Ž
the exit from the garage mode will be signalled by a
long
flash of the direction indicator lights
and a
long
acoustic tone;
•
remove the electronic key.
9 - DISARM USING YOUR EMERGENCY PIN CODE
ISUT270-278UK.p65
12/05/2006, 10.24
12
