Laser Mech FiberCUT HR, Operation Manual

Page: 29 / 62

PLMNL0252 REV. B Effective Date: 10/16/17
23
FiberCUT
®
HR Operation Manual
4.4.2 HSU Curve
See Figure 32 .
1. Click the Settings menu in the
upper left corner of the Main
screen and hover over
HSU
Curve .
2. Click Linear, Optimized , or Other
as desired.
Figure 32
Load Curve is an advanced
function that should only be
performed under direction of
Laser Mechanisms support.
4.4.3 HSU Parameters
This menu provides access to
advanced settings in the height sensor
which are preset at the factory. It
should only be used under the
direction of a Laser Mechanisms
technician.
4.4.4 Temperature/Voltage Limits
The acceptable upper temperature
limit can be set as desired within the
stated range for the following
components:
Upper Cover Glass
Collimating Parabola
Process Monitor
Focusing Parabola
Lower Cover Glass
Height Sensor
The acceptable upper voltage limit
can be set as desired within the stated
range for the Scattered Light detector.
Temperature and voltage readings
outside the acceptable range will
result in a fault condition.
To modify the desired upper limit:
1. Click the Settings menu in the
upper left corner of the Main
screen and hover over
Temp/Voltage Limits . Click on the
desired range to set. See Figure
33 .
Figure 33