3
6. Operating instructions
6.1 Overview
1
Control lamp
2
Ultrasound speaker
3
ON/OFF switch
4
Plus connection cable
5
Minus connection cable
6
Fuse holder
7
High-voltage cable
8
Contact plates
6.2 Preparation
Before installation, it is necessary to remove the scent mark left by the marten! We recommend the use of our LAS pre-treatment spray to
remove the marten scent mark or, at least, an engine wash.
6.3 Installation
Ultrasound functions in a similar way to the light cone of a torch and does not cut through material. The sound should be able to distribute its-
elf without impedance. For this reason, mount the device in the upper section of the engine compartment so that the sound can be distributed
without impedance.
Attach the high-voltage cable (Position 7 in the overview) to the contact plates (Position 8 in the overview) in such a way that the conductive
exposed surfaces of the plates do not touch any other parts.
Caution:
Do not mount the marten repellent device in the vicinity of hot or rotating elements of the engine.
6.4 Connection
Caution:
Disconnect the battery before carrying out any work on the electrical system of your vehicle. To do this, read the manual of
your vehicle or ask your specialist workshop.
Connect the red plus connection cable (Position 4 in the overview) of the marten repellent device to the steady plus, behind the
fuse of your vehicle. Connect the black minus connection cable (Position 5 in the overview) to the ignition switching plus, terminal 15, for the
majority of vehicles. The device then switches itself off when the ignition is switched on. Make sure that no other functions are influenced.
Check the correct connection of the marten repellent device. Connect the vehicle battery again. To do this, read the manual of your vehicle or
ask your specialist workshop.
6.5 Operation
Switch off the ignition of your vehicle. Press the ON/OFF switch (Position 3 in the overview) to switch the marten repellent device off. The con-
trol lamp (Position 1 in the overview) now flashes at an interval of approximately 3 seconds. In this interval, the ultrasound speaker (Position 2
in the overview) emits an ultrasound sinus tone. Once switched on high-voltage is applied permanently to the contact plates.
You can leave the marten repellent device in this state, even during travel (since the device is switched off when the ignition is switched on).
6.6 Replacing the fuse
To replace the fuse, unscrew the fuse holder (Position 6 in the overview) by rotating both halves of the housing in an anti-clockwise direction.
Remove the defective fuse. Replace a new fuse of the same strength (see section 3. Specifications) in the fuse holder. Screw both housing
halves together by rotating clockwise.
