TPM-GL20004-16CC
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
BATTERY INSTALLATION AND REMOVAL FOR TRANSMITTER
Remove battery cover: for wireless hand-held transmitter, remove phillips head screw to remove cover. With battery
compartment now exposed, insert GP 23A 12V batteries according to the correct polarity or gently remove batteries by
grabbing the positive end and lifting up.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Light is controlled with a programmable remote with 2187 different channels. This feature allows you the freedom to
change the channel selection, and the receiver re-learns the new selection. This light has been pre-programmed at the
factory, and it is not necessary to re-program the transmitter, unless you experience outside interference.
To program transmitter:
1. IMPORTANT
Disconnect power.
2.
Remove battery cover from remote control.
3.
Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive, negative and
neutral. Use a small screwdriver and select a position for each dip switch. *Please note that the orientation of
the +/- switch positions may vary among different models of wireless remote controls.
4.
Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.
5.
Replace battery cover.
a.
Depress the on/off button and hold it down. Red LED will light.
b.
While holding the on/off button down, reinstall the power (replace fuse or connect vehicle battery).
c.
Keep on/off button depressed for 5-6 seconds, and then release. The light should now be programmed.
USAGE:
This light is intended for off-road and utility use only
This light is intended to be mounted outside the vehicle while in use
This light may only be disassembled and repaired by an authorized representative
MISUSE:
This light is not approved for road or highway use
This light is not approved for underwater use
This light is not approved for inverted mounting
This light is not approved for use inside a vehicle or enclosure and power should be disconnected prior to
placing the light in such circumstance
This light may be damaged if operated in icing conditions
This light may only be dismantled by an authorized representative
Any violation of the above referenced misuses will be considered grounds for warranty refusal
IMPORTANT SAFETY INFORMATION
This symbol is to alert you to important operating or servicing instructions that appear in your instructions. Always follow
basic safety precautions when using this product to reduce the risk of injury, fire or electric shock.
This light is for off road and utility use only. It is not designed for road use as a driving light.
The Golight complies with Part. 15.105 of the FCC Rules. This equipment has been tested and found to comply with the limits for a
Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
FCC RULE Part. 15.21 - Changes or modifications made by the user not expressly approved by Larson Electronics, LLC for
compliance could void the user’s authority to operate the equipment.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE
AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
