The GL-9900 is a Portable Searchlight designed to
be permanently or temporarily attached to a vehicle
for your specific use. The 2-Speed Searchlight with
Directional Flexibility is controlled by a wireless
remote, which gives the operator a full 370°
horizontal rotation and a 135° vertical tilt with
fingertip control. The GL-9900 provides superior light
penetration with state of the art LED technology.
GL-9900 Hard Wired - Permanent Mount:
GL-9900 Searchlight
Wireless Remote Control
Permanent Mounting Shoe
(Press spring lock to release and remove light.)
Permanent Mounting Gasket
MOUNTING INSTRUCTIONS
Temporary (Suction):
1.
Always clean mounting surface with a clean
cloth.
2.
Remove light from permanent mount shoe by
depressing spring-loaded lock and sliding light
out.
3.
Place suction base on clean, dry surface and
move side lever into the locked position.
WARNING:
Check the suction cup frequently to
ensure that suction strength
is
maintained.
Temperature variations, rough terrain, grease and
dirt affect the length of time that the suction cup will
remain in place. Suction mounting is not
recommended for road use.
Permanent:
1.
On clean, dry surface, place gasket and shoe
in desired location. Using 3/16” screws, attach
shoe to vehicle.
2.
Slip the Golight into the shoe. Verify that the
spring lock secures the Golight into the shoe.
An optional magnetic mounting shoe is
available (see web store).
Route the power cord into the vehicle through a
door frame and connect to 12V power outlet.
PROGRAMMABLE REMOTE INSTRUCTIONS
The GL-9900 is controlled with a programmable
remote with 2187 different channels. This feature
allows you the freedom to change the channel
selection, and the receiver relearns the new
selection.
PROGRAMMING THE TRANSMITTER.
This light has been pre-programmed at the factory, it
is not necessary to re-program the transmitter, but is
recommended.
PROGRAMMABLE REMOTE INSTRUCTIONS
The GL-9900 Light is controlled with a programmable
remote with 2187 different channels. This feature
allows you the freedom to change the channel
selection, and the receiver re- learns the new
selection. This light has been pre-programmed at the
factory, and it is not necessary to re-program the
transmitter, unless you experience outside
interference. To program transmitter:
1. IMPORTANT
Disconnect power.
2.
Remove battery cover from remote control.
3.
Set the 7 dip switches to a selection of your
choice. There are 3 positions on each; positive,
negative and neutral. Use a small screwdriver and
select a position for each dip switch. *Please note
that the orientation of the +/- switch positions may
vary among different models of wireless remote
controls.
4.
Insert both GP 23A 12V batteries. Be sure
batteries have adequate charge.
5.
Replace battery cover.
a.
Depress the on/off button and hold it down.
Red LED will light.
b.
While holding the on/off button down,
reinstall the power (replace fuse or connect
vehicle battery).
c.
Keep on/off button depressed for 5-6
seconds, and then release. The light should
now be programmed.
BATTERY INSTALLATION AND REMOVAL FOR
TRANSMITTER
Remove Battery Cover: remove the Phillips head
screw securing the battery cover then remove the
cover. With the battery compartment now exposed,
insert batteries according to correct polarity.
Remove the batteries by gripping the positive end of
each battery and lifting.
Use only 12v-A23 batteries in the Golight remote
control
OPERATION OF GL-9900
1.
Place your light into the mounting shoe or attach
to the outside of your vehicle (see mounting
instructions).
