![background image](http://html1.mh-extra.com/html/larson-electronics/atex-ehl-1123-led-50-epp/atex-ehl-1123-led-50-epp_operating-instructions-manual_3720591010.webp)
Commissioning
10
Inspection Light LED
ATEX-EHL-1123-LED
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8
Commissioning
• Make sure that the plug is fitted correctly.
• Check that the cable is clamped properly.
• Inspect cable glands for damage.
• Check the light for visible damage.
9
Maintenance and repair
9.1
Maintenance
• Determine the type and extent of inspections in compliance with the relevant national
regulations.
• Adapt inspection intervals to the operating conditions.
The following tests and measures must be carried out during regular maintenance.
DANGER
Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation and function before
commissioning.
• Comply with the national regulations.
WARNING
Risk of electric shock or malfunctioning of the device due to unauthorized
work!
Non-compliance can result in severe injuries and material damage.
• Work performed on the device must only be carried out by appropriately
authorized and qualified electricians.
Observe the relevant national regulations in the country of use.
Check
Measures
the permissible ambient temperature
If exceeding the permissible ambient
temperature or falling below the device
must be taken out of operation.
the enclosure components for formation of
cracks and damage.
Replace the exchangeable enclosure
components. If the enclosure components
are non-exchangeable, the device must be
taken out of operation.
s
i
e
c
i
v
e
d
e
h
t
fI
e
s
u
d
e
d
n
e
t
n
i
s
ti
not used according to its
intended use, it must be taken out of
operation.
Larson Electronics, LLC.
(800) 369-6671 | [email protected]
www.LarsonElectronics.com